Add Satellite Imagery: BirdsEye broken

[ConiKost]

I am not sure, if that is a bug or I do need perform a hard reset, but I am not able to show any BirdsEye stuff. If I do choose "Satellite" in predefinied Map Sets, it gets enabled for a second and then disables. All my JNX files from BaseCamp are as a result not shown on map, but are all listed available in Outdoor Maps+. Firmware 14.80. It was working with 13.20 just fine.

[GPSrChive]

What happens if you enable 'Satellite Imagery' from the Map Layer Menu on the map page? Is your BirdsEye satellite imagery then displayed?

[ConiKost]

What happens if you enable 'Satellite Imagery' from the Map Layer Menu on the map page? Is your BirdsEye satellite imagery then displayed?

No, it's not being shown. But I also noticed, if I click von 'Satellite' in Map Layer menu, its highlighted as enabled. But after I close the menu and reopen, it's again disabled :/ So basically, it never enables?

[GPSrChive]

Please open a ticket with Garmin support, this behavior is no reproducable here.

[ConiKost]

Please open a ticket with Garmin support, this behavior is no reproducable here.

Already done and waiting for answer. Will reply, when I have an answer.

[ConiKost]

Still broken with 15.00, but I noticed, that opening a single JNX file in Outdoor Maps+ menu shows it on the map. But enabling via map set does not work and also downloaded satellite images on Montana are never shown.

[GPSrChive]

Hopefully they will have these new features sorted quickly! It is all a big mess currently....

[ConiKost]

Fixed with 15.10.