Route Point symbols are not displayed on Map [Bug 71]

[ConiKost]

Wow. I am really surprised. They changed it with 10.80! Blue Pin symbols are back and indicate, which waypoints belong to active route.

[ConiKost]

A small notice. When not using a route, but a simple A->B route via Where To? and adding afterwards a via point, the blue pin needle is missing and this small square is again being used.

[ConiKost]

A small notice. When not using a route, but a simple A->B route via Where To? and adding afterwards a via point, the blue pin needle is missing and this small square is again being used.

This is still the case in firmware 10.90.

[ConiKost]

Not changed in 13.10.

[ConiKost]

A small notice. When not using a route, but a simple A->B route via Where To? and adding afterwards a via point, the blue pin needle is missing and this small square is again being used.

There is a change in 14.80, which makes it worse. Simple A->B routes now also don't have any blue needle anymore. Its gone, while pre-planed routes still have it. Can anyone confirm this?

[ConiKost]

A small notice. When not using a route, but a simple A->B route via Where To? and adding afterwards a via point, the blue pin needle is missing and this small square is again being used.

There is a change in 14.80, which makes it worse. Simple A->B routes now also don't have any blue needle anymore. Its gone, while pre-planed routes still have it. Can anyone confirm this?

This issue still exists for me in 15.00, 15.10, 15.20 and 16.50 Really annoying, as an added via point is now hard to see.