Diagnostic Page
  ANT/BLE/BT Tests
  BNS Tests
  Compass Tests
  Device Info
  Display Tests
  Iridium Tests
  Safety Tests
  Wi-Fi Tests
  Boot Setup



View Device Information and Perform Diagnostic Tests:
  • Start with the GPSMAP 67 powered off.
  • Press and release the (Power) button.
  • Immediately Press and hold the (Enter) button.
  • The GPSMAP 67 will boot into a diagnostic menu.
  • Release the (Enter) button.
  • Select the desired test and press (Enter):

ANT/BLE/BT Tests
 
  • View software and chipset versions.
  • Press (Menu) to cycle through ANT, BLE and BT tests.
  • Press (Down) to cycle available test options.
  • Press (Up) to change selected test option.
  • Press (Enter) to start selected test.
  • Press (Quit) to exit menu.
 
 
BNS Tests
 
  • View BNS Adv/Conn Test status.
  • Press (Up) to cycle Adv Interval.
  • Press(Down) to cycle Tx Power.
  • Press (Enter) to cycle State (Ready/Advertising).
  • Press (Quit) to pause test State (Wait).
  • Press (Page) to exit.
 
 
Compass Tests
 
  • View accelerometer and magnetometer values in real time.
  • View compass true north and magnetic heading values in real time.
  • Press (Quit) or (Page) to exit.
 
 
Device Info
 
  • View Device Hardware, Software and GPS Chipset versions.
  • View ESN and IMEI numbers.
  • View PCB and Display versions.
  • View RAM type and ID, Charge Rate, Total device time and time since last reset.
  • View USB-C connection ID, battery temperature (°C), voltage (mV), current flow (mA) and charge level (capacity).
  • View Backlight value, Barometric pressure and ambient temperature (°C).
  • View Manifest status - Press (Mark) to generate a new \Garmin\manifest.txt file.
  • Press (Quit) to exit.
 
 
Display Tests
 
  • Press (Left)/(Right) to navigate available display tests.
  • Press (Quit) or (Page) to exit.
 
 
Iridium Tests
 
  • Select from available Iridium tests.
  • Press (Enter) to activate selected test and view results.
  • Press (Quit) or (Page) to exit.
 
 
Safety Tests
 
  • Select desired option and press (Enter) to toggle on/off.
  • Press (Quit) or (Page) to exit.
 
 
Wi-Fi Tests
 
  • Press (Menu) to cycle test type (TX, RX, CW).
  • Press (Down) to change Wi-Fi channel.
  • Press (Up) to change duty cycle.
  • Press (Enter) to start selected test.
  • Press (Quit) or (Page) to exit.
 
 
Boot Setup
 
  • Press (Enter) to toggle 'Boot Into Test Mode' on/off.
  • Press (Quit) or (Page) to exit.