Page 1 of 1
Sight ´N Go problem
Posted: Tue Nov 17, 2020 3:07 pm
by Oli77
I’ve set the compass to mills but it still showing in degrees on the center
Re: Sight ´N Go problem
Posted: Tue Nov 17, 2020 3:11 pm
by GPSrChive
Firmware Version?
Re: Sight ´N Go problem
Posted: Tue Nov 17, 2020 3:19 pm
by Oli77
5.0 , very strange
Re: Sight ´N Go problem
Posted: Tue Nov 17, 2020 3:22 pm
by GPSrChive
Thank you.
Please, everyone, report this issue to Garmin via email and phone calls where possible.
Garmin Contact information is available at GPSrChive > GPSMAP 66 > Troubleshooting.
Re: Sight ´N Go problem
Posted: Tue Nov 17, 2020 3:24 pm
by Oli77
Thank you