GPSrChive Discussion Forum

I am not sure, if that is a bug or I do need perform a hard reset, but I am not able to show any BirdsEye stuff. If I do choose "Satellite" in predefinied Map Sets, it gets enabled for a second and then disables. All my JNX files from BaseCamp are as a result not shown on map, but are all listed available in Outdoor Maps+. Firmware 14.80. It was working with 13.20 just fine.

What happens if you enable 'Satellite Imagery' from the Map Layer Menu on the map page? Is your BirdsEye satellite imagery then displayed?

GPSrChive wrote: ↑Sat Nov 12, 2022 12:57 pm What happens if you enable 'Satellite Imagery' from the Map Layer Menu on the map page? Is your BirdsEye satellite imagery then displayed?

No, it's not being shown. But I also noticed, if I click von 'Satellite' in Map Layer menu, its highlighted as enabled. But after I close the menu and reopen, it's again disabled :/ So basically, it never enables?

Please open a ticket with Garmin support, this behavior is no reproducable here.

GPSrChive wrote: ↑Sat Nov 12, 2022 2:46 pm Please open a ticket with Garmin support, this behavior is no reproducable here.

Already done and waiting for answer. Will reply, when I have an answer.

Still broken with 15.00, but I noticed, that opening a single JNX file in Outdoor Maps+ menu shows it on the map. But enabling via map set does not work and also downloaded satellite images on Montana are never shown.

Hopefully they will have these new features sorted quickly! It is all a big mess currently....

Fixed with 15.10.