Explore is a bit funky with how it handles current activity tracking
Posted: Sat Aug 20, 2022 5:33 pm
While I'm sure this is "working as designed", Explore can be a bit funky and annoying with how "Current Activity" tracking is handled with paired devices. Specifically, if the current track is not saved on the device, it remains in a pending/limbo mode on the paired phone forever and cannot be deleted, saved, or anything else until it is saved on the GPS receiver and then synced to Explore.
I have observed this behavior on both a GPSMAP 64st and an Inreach MINI 2. And while just an annoyance, and solvable by turning the GPS receiver device back on to save the current track and sync, it could go beyond an annoyance if, say, you forget and the GPS receiver isn't with you. I didn't test if removing the paired device from the phone will clear a current activity in this state, but I sure hope that's the case.
It would be really nice if a track in this state could be manipulated - saved or deleted. It's silly to have a pending, current activity, when the GPS receiver has been turned off for awhile. I'm totally fine if turning the GPS receiver back on resyncs the pending track and brings it back into this state.
I have observed this behavior on both a GPSMAP 64st and an Inreach MINI 2. And while just an annoyance, and solvable by turning the GPS receiver device back on to save the current track and sync, it could go beyond an annoyance if, say, you forget and the GPS receiver isn't with you. I didn't test if removing the paired device from the phone will clear a current activity in this state, but I sure hope that's the case.
It would be really nice if a track in this state could be manipulated - saved or deleted. It's silly to have a pending, current activity, when the GPS receiver has been turned off for awhile. I'm totally fine if turning the GPS receiver back on resyncs the pending track and brings it back into this state.