Firmware 2.50 Issues
Posted: Thu Feb 28, 2019 1:19 am
I have experienced a number of issues after updating the Firmware to 2.50.
1 The unit sometimes turns off when changing pages. This has happened a number of times.
2 After selecting a geocache to go to, then going back to the geocaching page I am presented with a list of geocaches, and have to again select one to go to.
3 On the small data screen selected for Distance to Destination; the distance showed 0km when actual distance is more than 10m. This distance did not change when the unit location was moved. Happened 2 times, then corrected itself.
4 Calibrating compass. I have raised this before. The 3rd stage calibration is very difficult to carry out successfully. This problem remains.
Anyone else have these issues?
1 The unit sometimes turns off when changing pages. This has happened a number of times.
2 After selecting a geocache to go to, then going back to the geocaching page I am presented with a list of geocaches, and have to again select one to go to.
3 On the small data screen selected for Distance to Destination; the distance showed 0km when actual distance is more than 10m. This distance did not change when the unit location was moved. Happened 2 times, then corrected itself.
4 Calibrating compass. I have raised this before. The 3rd stage calibration is very difficult to carry out successfully. This problem remains.
Anyone else have these issues?