GPSrChive Discussion Forum

If you configure "GPS page" for Compass, you can see, that the suffix for values of "GPS Elevation" ans "GPS Accuary" is a little bit ouf of display shown. See screenshot. Firmware 13.20.

Steps to reproduce:
0) Put GPS to demo mode (or have real GPS enabled)
1) Configure Map View -> Menu -> Map Setup -> Dashboard to 'Compass'
2) Go back to Map View
3) Click on shown Compass
4) Open Menu -> Change Dashboard
5) Choose Satellite

Same issue happens, when Satellite Dashboard is directly shown on map view.

the units field is nicely designed for imperial "ft" the letters being stacked one on top of each other. I see no allowance for a wide character like the letter m.

Garmin have been advised!

(now we hold our breath!)

Seems fixed in 14.80. Values are not out of display.