Saved Tracks + Recording Controls Elevation Plot Issue [Bug 129]
Posted: Sun Jun 28, 2020 5:07 pm
GPSMAP 66st software 4.20, gps software 2.70.
Hi.
I have observed an issue while looking into Recorded activities or Saved tracks.
If one has a saved activity or a saved track.
Enters the recording, goes to the tab for the altimeter and do one of the following things.
A)
1. Press D-pad up or down to enter into the elevation plot.
2. Press Menu -> adjust zoom ranges.
3. After adjusting press Quit.
4. Press up or down to re-enter the elevation plot.
5. Now try to move left or right, instead of moving along the elevation plot, the unit moves to the information or the map tab (not expected).
B)
1. Press D-pad up or down to enter into the elevation plot.
2. Move left or right to a position on the plot.
3. Press Menu -> View map.
3. After viewing map press Quit.
4. The elevation plot stills shows the position you selected.
5. Now try to move left or right, instead of moving along the elevation plot, the unit moves to the information or the map tab (not expected). This also occurs if one first tries to press up or down to select an elevation plot.
A new feature i would like to suggest is that the elevation plot should calculate and show an "current speed" at the plot position.
Something which one can see in some computer program, but it could be a nice feature on the device as well.
I don't know if sensor data is stored and could be shown as well in the plot. For example the current temperature, cadence and other information that connected devices send to the GPS unit. Since i don't have such sensors i cannot verify how it works, but i think it could be interesting for persons who has such sensors.
I understand that it would be limited to be saved only as often as a point is saved, but it would still be a lot better and nicer than nothing.
Hi.
I have observed an issue while looking into Recorded activities or Saved tracks.
If one has a saved activity or a saved track.
Enters the recording, goes to the tab for the altimeter and do one of the following things.
A)
1. Press D-pad up or down to enter into the elevation plot.
2. Press Menu -> adjust zoom ranges.
3. After adjusting press Quit.
4. Press up or down to re-enter the elevation plot.
5. Now try to move left or right, instead of moving along the elevation plot, the unit moves to the information or the map tab (not expected).
B)
1. Press D-pad up or down to enter into the elevation plot.
2. Move left or right to a position on the plot.
3. Press Menu -> View map.
3. After viewing map press Quit.
4. The elevation plot stills shows the position you selected.
5. Now try to move left or right, instead of moving along the elevation plot, the unit moves to the information or the map tab (not expected). This also occurs if one first tries to press up or down to select an elevation plot.
A new feature i would like to suggest is that the elevation plot should calculate and show an "current speed" at the plot position.
Something which one can see in some computer program, but it could be a nice feature on the device as well.
I don't know if sensor data is stored and could be shown as well in the plot. For example the current temperature, cadence and other information that connected devices send to the GPS unit. Since i don't have such sensors i cannot verify how it works, but i think it could be interesting for persons who has such sensors.
I understand that it would be limited to be saved only as often as a point is saved, but it would still be a lot better and nicer than nothing.