When you change to a new profile and start routing, it uses the routing method from the last selected profile. When you then go and re-select the currently configured routing method, it recalculates using the correct routing method.
Test methodology (100% repeatable):
1. Select Driving profile (that has been previously configured for Automobile Driving in Setup / Routing)
2. Select a route from the Route Planner, View Map and select Go (and it will calculate the route)
3. Visually confirm the route is using roads and not paths
4. Stop Navigation
5. Select Hike profile (that has been previously configured for the Hiking activity in Setup / Routing)
6. Select the same route from the Route Planner, View Map and select Go (and it will calculate the route using Automobile Driving)
7. Go to Setup / Routing and visually confirm it is set for Hiking
8. Re-select Hiking again, and you will hear the single beep as the route is re-calculated for Hiking
9. Return to the map page and confirm the route is now using paths etc
(Reported to Garmin via email)
I belatedly realised that RaoulBE reported this same issue back in March: https://www.gpsrchive.com/Discussion/vi ... f=36&t=201
Bug: Routing uses method from last selected profile [Bug 52]
-
- Posts: 98
- Joined: Fri Jan 04, 2019 2:48 am
- GPSrChive
- Site Admin
- Posts: 3921
- Joined: Fri Jan 20, 2017 11:29 pm
Re: Bug: Routing uses method from last selected profile [Bug 52]
Which firmware version is your GPSMAP 66 running?
-
- Posts: 98
- Joined: Fri Jan 04, 2019 2:48 am
Re: Bug: Routing uses method from last selected profile [Bug 52]
I believe it is the latest:
Software (firmware?) version 3.00
GPS Software version 2.60
Software (firmware?) version 3.00
GPS Software version 2.60
- GPSrChive
- Site Admin
- Posts: 3921
- Joined: Fri Jan 20, 2017 11:29 pm
Re: Bug: Routing uses method from last selected profile [Bug 52]
Thank You!
Posted to Common Issues page as Bug 52.
Posted to Common Issues page as Bug 52.
-
- Posts: 98
- Joined: Fri Jan 04, 2019 2:48 am
Re: Bug: Routing uses method from last selected profile [Bug 52]
Just to repeat what I posted on the other thread on the same issue, the bug only happens when the profile being switched to has the routing method select to "Prompted". If the routing method has been selected to "minimise time" etc, it works correctly.
Also, if the GPSr is already routing when you switch profile (ie you don't stop routing before switching profile), it works correctly (even if the new routing method is set to Prompted).
Garmin Australia say they can replicate the problem.
Also, if the GPSr is already routing when you switch profile (ie you don't stop routing before switching profile), it works correctly (even if the new routing method is set to Prompted).
Garmin Australia say they can replicate the problem.
- GPSrChive
- Site Admin
- Posts: 3921
- Joined: Fri Jan 20, 2017 11:29 pm
Re: Bug: Routing uses method from last selected profile [Bug 52]
Thank you for the updated information!