Disconnecting Monty 650 LCD/Touch screen.
Posted: Tue Jun 28, 2022 5:49 pm
I took a peek inside the Montana 650 so see how the screen disconnects. There are two cables:
- a flexi cable for the screen which is connected to the mother board
- a second two-wire block connector that I believe is for the backlight.
It's not obvious to me how these connectors are 'released'.
In the image below, to release the flexi cable header (circled in yellow), is the black 'bar' on the header pulled 'out' (or up?). Looks like the small two-wire block connector (circled in white) pulls out to the left - what's holding it in place?
Can anyone clarify how these connectors are release?
- a flexi cable for the screen which is connected to the mother board
- a second two-wire block connector that I believe is for the backlight.
It's not obvious to me how these connectors are 'released'.
In the image below, to release the flexi cable header (circled in yellow), is the black 'bar' on the header pulled 'out' (or up?). Looks like the small two-wire block connector (circled in white) pulls out to the left - what's holding it in place?
Can anyone clarify how these connectors are release?