Page 1 of 1

Databases not rebuilt on boot

Posted: Mon Aug 12, 2019 9:25 am
by wtremmel
Hello,

yesterday I had the strange issue that my GPSMap 66st did not rebuilt its internal databases at boot time.
I tried everything from the book - removing/adding SD card, adding tracks, routes, Geocaches - nothing worked.

(I could see it did not rebuild as a route I removed the .gpx file was still visible when I chose "Find" / "Routes", when selecting the (non-existing) route the GPSmap crashed) - also geocaching .gpx files I added did not show up. This happened both with sd card and internal storage.

I was nearly to give up and do a master reset until I made one last try with batteries instead of using USB power like I did before, and for whatever reason it then rebuilt the database and everything is working again.

I know that this is not much of an error report as I could not (and really do not want to) recreate the error, but perhaps someone else picks this up and can supply more information on how to force a database rebuild.

best regards
Wolfgang

Re: Databases not rebuilt on boot

Posted: Wed Oct 09, 2019 11:28 pm
by ivhs72
I've had a consistent problem that still happens even with the latest update. When I load my pocket queries, it takes forever for them to update (to the point of draining the batteries).

Here is what I have to do:
1) load the pocket queries using copy/paste to the/GPX folder in the device (I'm using USB power from my PC at that point)
2) I disconnect, and then turn the GPSr on. In a couple of minutes, it does boot, and I can see the geocache icons. But when I look at one, there is no information in it, totally blank, and it locks up the GPSr.
3) I then remove the batteries to power it down. I replace the batteries, and then power it up again by plugging it into AC power from the wall.
4) It powers on, and then takes more than 4 hours to update. I'm not sure how long because I do it before I got to bed, and when I get up in the morning, everything is updated.

This is the only way I've found to update my geocaches.

Re: Databases not rebuilt on boot

Posted: Thu Oct 10, 2019 2:59 am
by GPSrChive
How many geocaches total in your PQs? How many files? How many MB total?

Re: Databases not rebuilt on boot

Posted: Thu Oct 10, 2019 3:12 pm
by robert
wtremmel wrote: Mon Aug 12, 2019 9:25 am Hello,

yesterday I had the strange issue that my GPSMap 66st did not rebuilt its internal databases at boot time.
I tried everything from the book - removing/adding SD card, adding tracks, routes, Geocaches - nothing worked.

(I could see it did not rebuild as a route I removed the .gpx file was still visible when I chose "Find" / "Routes", when selecting the (non-existing) route the GPSmap crashed) - also geocaching .gpx files I added did not show up. This happened both with sd card and internal storage.

I was nearly to give up and do a master reset until I made one last try with batteries instead of using USB power like I did before, and for whatever reason it then rebuilt the database and everything is working again.

I know that this is not much of an error report as I could not (and really do not want to) recreate the error, but perhaps someone else picks this up and can supply more information on how to force a database rebuild.

best regards
Wolfgang
I have noticed different boot up behavior when batteries have been removed for 10-20s or so to that when batteries are quickly changed or normal power on. It takes much longer from a cold boot. I think there must be an element of caching data which is used to speed up the power up sequence in normal warm boot. If this cache gets corrupt then a battery removal may be just the cure.