Page 1 of 1

Bug: Routing uses method from last selected profile [Bug 52]

Posted: Thu May 23, 2019 8:55 am
by steerage250
When you change to a new profile and start routing, it uses the routing method from the last selected profile. When you then go and re-select the currently configured routing method, it recalculates using the correct routing method.

Test methodology (100% repeatable):
1. Select Driving profile (that has been previously configured for Automobile Driving in Setup / Routing)
2. Select a route from the Route Planner, View Map and select Go (and it will calculate the route)
3. Visually confirm the route is using roads and not paths
4. Stop Navigation
5. Select Hike profile (that has been previously configured for the Hiking activity in Setup / Routing)
6. Select the same route from the Route Planner, View Map and select Go (and it will calculate the route using Automobile Driving)
7. Go to Setup / Routing and visually confirm it is set for Hiking
8. Re-select Hiking again, and you will hear the single beep as the route is re-calculated for Hiking
9. Return to the map page and confirm the route is now using paths etc

(Reported to Garmin via email)

I belatedly realised that RaoulBE reported this same issue back in March: https://www.gpsrchive.com/Discussion/vi ... f=36&t=201

Re: Bug: Routing uses method from last selected profile [Bug 52]

Posted: Thu May 23, 2019 1:01 pm
by GPSrChive
Which firmware version is your GPSMAP 66 running?

Re: Bug: Routing uses method from last selected profile [Bug 52]

Posted: Thu May 23, 2019 1:09 pm
by steerage250
I believe it is the latest:
Software (firmware?) version 3.00
GPS Software version 2.60

Re: Bug: Routing uses method from last selected profile [Bug 52]

Posted: Thu May 23, 2019 1:11 pm
by GPSrChive
Thank You!

Posted to Common Issues page as Bug 52.

Re: Bug: Routing uses method from last selected profile [Bug 52]

Posted: Mon Jun 03, 2019 12:08 am
by steerage250
Just to repeat what I posted on the other thread on the same issue, the bug only happens when the profile being switched to has the routing method select to "Prompted". If the routing method has been selected to "minimise time" etc, it works correctly.

Also, if the GPSr is already routing when you switch profile (ie you don't stop routing before switching profile), it works correctly (even if the new routing method is set to Prompted).

Garmin Australia say they can replicate the problem.

Re: Bug: Routing uses method from last selected profile [Bug 52]

Posted: Mon Jun 03, 2019 2:13 am
by GPSrChive
Thank you for the updated information!